Common faults and maintenance methods of packing machine

1, the solid-state off the electrical burnout, temperature control table damage, thermocouple damage thermometer can not control the temperature, the repair method is to change the license even, replace the temperature control table, replace the heating element.

2, the speed is too fast, poor heat sealing the inner envelope, the seal will appear leaky or not solid when the temperature is too low, the method of maintenance is to make the speed slow down, raise the temperature, replace the film material.

3, the pressure is wrong, cylinder pendulum loose, heating temperature is low, heat roller and drive roller will appear when the heat seal is not parallel, repair method is to adjust the parallelism, adjust the temperature and pressure to make it tight.

And note that before the power supply must be inserted into the induction aviation plug, and tighten the screws; can not be covered with metal and metal containers, but can not be placed on the metal table press the start button, otherwise it will damage the machine; work process Should often touch the surface of the sensor head, check whether overheating, such as found hot to stop heating, to be cooled and then work; in pillow packing body there will be high voltage, the floor has electricity, maintenance must pay attention to avoid personal danger.

Welcome to contact me for more  information.

http://www.noodlesmake.com/product/non-fried-noodle/auto-instant-noodle-packing.html